| 轴外圆及锥套内孔同时磨损并导致飞轮端面磨损 |
| 添加时间：2019/10/22 14:39:26 浏览次数： |
| 锥套与轴配合面间的接触面积不够。按设计，接触面积应占配合面积的80，才能形成足够的摩擦力以克服锥套的惯性力，以前在轴零件装配时，没有掌握好方法，所以接触面积小于80，使锥套在轴上产生松动，一旦松动，轴外圆及锥套内孔同时磨损并导致飞轮端面磨损，使设备不能运转。 The contact area between the taper sleeve and the shaft mating surface is not enough. According to the design, the contact area should account for 80% of the mating area, so as to form enough friction force to overcome the inertia force of the taper sleeve. In the past, when the shaft parts were assembled, there was no good method, so the contact area was less than 80, which made the taper sleeve loose on the shaft. Once loose, the outer circle of the shaft and the inner hole of the taper sleeve were worn at the same time, resulting in the wear of the flywheel end face, which made the equipment unable to operate. 金属撕碎机是一款集废金属制品预碎、中碎、除杂、拆解、加密成型的关键设备。 Metal shredder is a key equipment for pre crushing, medium crushing, impurity removal, disassembly and densification of waste metal products. 常用的多轴撕碎机刀片有双轴刀、三轴刀和四轴刀，材料要选择耐磨性好、韧性好、强度高、抗冲击力强的钢材。 The commonly used blades of multi axis shredder are double axis knife, three axis knife and four axis knife. The material should be steel with good wear resistance, toughness, strength and impact resistance. |
| 上一页 我国的塑机在精确控制层厚技术上还难以与国外相比 |
| 下一页 门窗胶条挤出机的优势 |
Copyright © 技术支持：遨游网络