| 塑料破碎机的维护与保养 |
| 添加时间：2018/3/15 16:55:57 浏览次数： |
| 塑料破碎机的维护与保养 Maintenance and maintenance of plastic crusher 1、应把塑料破碎机安置通风位置,保证电机工作热量散发,延长其寿命. 1, the plastic crusher should be placed in the ventilation position to ensure the motor heat emission and prolong its life. 2、应定期对轴承加注润滑油,保证轴承间的润滑性. 2. The lubricating oil should be added to the bearing regularly to ensure the lubricity of the bearings. 3、定期检查刀具螺丝,全新塑料破碎机使用1小时后,用工具紧固动刀,定刀的螺丝,加强刀片与刀架间的固定性. 3, regular inspection tool screw, new plastic crusher after 1 hours of use, with the fastening tool knife, knife set screws, strengthen fixed blade and tool room. 4、为保证刀具切口的锋利度,应常检查刀具,保证其锋利度,减少由于刀锋钝缺而引起其它部件的不必要损坏. 4. To ensure the sharpness of the cutting tool, the cutters should be checked regularly to ensure the sharpness of the cutting tools and to reduce the unnecessary damage to other parts due to the blunt knife edge. 5、更换刀具时,动刀与定刀之间的间隙:20HP以上破碎机0.8MM为佳,20HP以下的破碎机0.5MM为佳.回收料越薄,间隙可适当调大. 5, time of tool change, the gap between the knife and the fixed knife: above 20HP crusher 0.8MM better, crusher 0.5MM below 20HP is preferred. Recycling material is thin, the gap can be properly adjusted. 6、第二次启动前,应先清除机室所剩余的碎料,减少启动阻力.应定期打开惯性罩和皮带轮罩,清除法兰盘下方出灰口,因塑料破碎机室排出粉料进入转轴轴承. Before the 6 and second start, the debris left in the machine room should be cleared first, and the starting resistance should be reduced. The inertia cover and belt pulley cover should be regularly opened, and the ash outlet under the flange should be cleared. 7、机器应保持良好接地. 7, the machine should be well grounded. 8、定期检查塑料破碎机皮带是否松驰,及时调紧. 8. Check the belt of the plastic crusher regularly or not, and adjust it in time. |
| 上一页 塑料破碎机顾名思义是破碎塑料材质的破碎机 |
| 下一页 塑料破碎机的维护与保养 |
Copyright © 技术支持：遨游网络