保定塑料机械设备厂

1、应把塑料破碎机安置通风位置,保证电机工作热量散发,延长其寿命.

1, should be placed the plastic crusher ventilated location, ensure heat motor, and prolong its life.

2、应定期对轴承加注润滑油,保证轴承间的润滑性.

2, should be conducted on a regular basis bearing filling lubricating oil, ensure between bearing lubrication.

3、定期检查刀具螺丝,全新塑料破碎机使用1小时后,用工具紧固动刀,定刀的螺丝,加强刀片与刀架间的固定性.

3, regular check tool screw, a new plastic crusher use after 1 hour, use tools to tighten the knife, knife of screw, strengthen the stability between blade and tool rest.

4、为保证刀具切口的锋利度,应常检查刀具,保证其锋利度,减少由于刀锋钝缺而引起其它部件的不必要损坏.

4, in order to guarantee the sharpness of cutter incision, often should check tool, ensure its sharpness, reduce because of the lack of the blunt edge cause unnecessary damage to other components.

5、更换刀具时,动刀与定刀之间的间隙:20HP以上破碎机0.8MM为佳,20HP以下的破碎机0.5MM为佳.回收料越薄,间隙可适当调大.

5, replacing knives, the knife and knife gap between: 0.8 MM is better, more than 20 HP crusher crusher 0.5 MM below 20 HP is preferred. The thinner recycled material, clearance can be appropriately adjusted.

6、第二次启动前,应先清除机室所剩余的碎料,减少启动阻力.应定期打开惯性罩和皮带轮罩,清除法兰盘下方出灰口,因塑料破碎机室排出粉料进入转轴轴承.

6, the second start, should first clear the rest of the machine room are broken material, reduce the starting resistance. Regularly open the inertial cover and belt guard, remove flange bottom ash, because of plastic crusher chamber discharge powder into the shaft bearing.

7、机器应保持良好接地.

7, the machine should maintain a good grounding.

8、定期检查塑料破碎机皮带是否松驰,及时调紧.

8, regular check whether plastic crusher belt relaxation, tighten in a timely manner.