1、塑料破碎机空载试车时需要按启动程序启动和停车，圆锥破碎机各有关连锁系统均应符合技术要求。
1. During no-load test run of plastic crusher, it is required to start and stop the crusher according to the starting procedure, and all relevant interlocking systems of cone crusher shall meet the technical requirements.
2、塑料破碎机空载试车时动锥正向或反向转动，每分钟不应超过15转。
2. During the no-load test run of the plastic crusher, the moving cone shall rotate in the forward or reverse direction, no more than 15 revolutions per minute.
3、塑料破碎机空载试车时圆锥齿轮不应有冲击和周期性噪声。
3. During no-load test run of plastic crusher, the bevel gear shall be free of impact and periodic noise.
4、塑料破碎机空载试车时润滑系统工作应当正常，给油压力应在0.5～1.5kg/cm2范围内，圆锥破碎机回油温度不超过50℃。
4. During no-load test run of plastic crusher, the lubricating system shall work normally, the oil supply pressure shall be within the range of 0.5-1.5kg/cm2, and the return oil temperature of cone crusher shall not exceed 50 ℃.
5、塑料破碎机空载试车时液压设备的液压调整装置，按其操作程序进行锁紧，调整圆锥破碎机排矿口达到使用要求的大小。
5. During the no-load test run of the plastic crusher, the hydraulic adjustment device of the hydraulic equipment shall be locked according to its operation procedure, and the discharge port of the cone crusher shall be adjusted to meet the use requirements.
6、塑料破碎机空载试车时正常连续运转时间不应少于2h，一般以达到鉴定要求为止。
6. The normal continuous operation time of the plastic crusher during no-load test run shall not be less than 2h, generally to meet the identification requirements