塑料破碎机使用时注意事项：

Matters needing attention in use of plastic crusher:

1、FHG系列塑料破碎机与动力机组要安装牢固。若需要塑料破碎机长期固定作业，应将其固定在水泥基础上；若需要塑料破碎机流动作业，机组应安装在用角铁制成的机座上，并且保证动力机（柴油机或电动机）和塑料破碎机的皮带轮槽处于同一回转平面。

1, FHG series plastic crusher and power unit should be installed firmly. If you need plastic crusher long-term fixed operations, should be fixed in the cement foundation; if the need for plastic crusher flowing work unit should be installed in the use made of the base angle, and to ensure that the engine (diesel or motor) and plastic crusher pulley groove in the same plane of rotation.

2、FHG系列塑料破碎机安装完后要检查各部紧固件的紧固情况，若有松动要给予以拧紧。同时要检查皮带松紧度是否合适。

2, FHG series plastic crusher after installation, to check the tightening parts fasteners, if there is loose, to be tightened. Check the tightness of belt at the same time.

3、FHG系列塑料破碎机起动前，先用手转动转子，检查一下齿爪、锤片及转子运转是否灵活可靠，破碎室内有无碰撞现象，转子的旋转方向是否与机箭头所指方向一致，动力机及塑料破碎机润滑是否良好。

3, FHG series plastic crushers before starting the first hand, the rotation of the rotor, check the tooth claw hammer, and the rotor is flexible and reliable, the crushing chamber has no collision phenomenon, the rotating direction of the rotor and the direction of the arrow machine, power machine and plastic crusher lubrication is good.

4、不要随便更换皮带轮，以防转速太高致使破碎室产生爆炸，或转速太低影响粉碎机的工作效率。

4, do not change the belt pulley, in order to prevent the high speed, resulting in the explosion of the chamber, or too low speed, affecting the efficiency of the mill.

5、塑料破碎机起动后应保持其先空转2~3min，没有异常现象后再投料工作。

5, it should keep the plastic crushing machine 2~3min idling after starting, and then feeding work no abnormal phenomenon.

6、工作中要随时注意塑料破碎机的运转情况，首先，送料要均匀，以防阻塞碎料室；其次，不要长时间超负荷工作。若发现有振动、杂音、轴承与机体温度过高，向外喷料等现象，应立即停机检查，排除故障后方可继续工作。

6, the work should pay attention to the operation of plastic crusher at any time, first of all, the feed should be uniform, in order to prevent blocking the crushing room; secondly, do not overload work for a long time. If there is vibration, noise, bearing and airframe temperature is too high, and other phenomena such as spraying, should immediately stop inspection, troubleshooting can continue to work.