塑料破碎机使用时注意事项： Note to the use of plastic crusher: 1、FHG系列塑料破碎机与动力机组要安装牢固。若需要塑料破碎机长期固定作业，应将其固定在水泥基础上；若需要塑料破碎机流动作业，机组应安装在用角铁制成的机座上，并且保证动力机（柴油机或电动机）和塑料破碎机的皮带轮槽处于同一回转平面。 The FHG series plastic crusher and power unit should be installed firmly. If a plastic crusher is required to be fixed for a long time, it shall be fixed on cement. If you need plastic crusher, the unit shall be installed on the made of Angle iron frame, and ensure that power generator (diesel or motor) and plastic crusher pulley groove in the same rotary surface. 2、FHG系列塑料破碎机安装完后要检查各部紧固件的紧固情况，若有松动要给予以拧紧。同时要检查皮带松紧度是否合适。 The FHG series of plastic crusher will be installed after the installation of the plastic crusher, check the fastening condition of all the fasteners, and tighten when it is loose. Also check if the belt tightening is appropriate. 3、FHG系列塑料破碎机起动前，先用手转动转子，检查一下齿爪、锤片及转子运转是否灵活可靠，破碎室内有无碰撞现象，转子的旋转方向是否与机箭头所指方向一致，动力机及塑料破碎机润滑是否良好。 3, FHG series plastic crusher, before starting to turn the rotor by hand first, check the tooth claw hammer, operation is flexible and reliable, and rotor broken interior presence of collision phenomena, the direction of rotation of the rotor machine direction arrow, engine lubrication and plastic crusher are in good condition. 4、不要随便更换皮带轮，以防转速太高致使破碎室产生爆炸，或转速太低影响粉碎机的工作效率。 Do not change the pulley, in case the speed is too high, the explosion in the broken room, or the speed of the machine is too low to affect the efficiency of the shredder. 5、塑料破碎机起动后应保持其先空转2~3min，没有异常现象后再投料工作。 The plastic crusher should be kept idle for 2 ~ 3min after starting, no abnormal phenomenon, no further feeding.